Aucun produit trouvé
Oil Mist Separators for Machining Equipment and Manufacturing Processes
Oil mist and emulsion aerosols are generated, for example, during turning, milling, grinding, or other machining processes that use cooling lubricants. A suitable oil mist separator captures these aerosols as close to the machine as possible and separates the liquid droplets from the airflow. This significantly reduces the burden on the work area, the machine’s surroundings, and downstream air ducts.
Typical Applications
✔ CNC machining centers
✔ Lathes and milling machines
✔ Grinding machines
✔ Processes involving cooling lubricants and emulsions
✔ Machines with enclosed or partially enclosed work chambers
Selection Criteria
The type and concentration of the aerosol, the flow rate required, the machine room, the operating time, and the cooling lubricants used are all critical factors. The question of whether fine dust or smoke is also produced can also influence the appropriate filter combination.
Multi-stage separation
Depending on the model, oil mist separators operate with multiple separation stages. Coarse droplets are separated early on, while finer aerosols are captured in subsequent stages. An appropriate staging system helps reduce the load on the fine filters and extend their service life.
Comparison of Key Design Parameters
| Criterion | Meaning | Planning Note |
|---|---|---|
| flow rate | Survey of the Machine Room | Do not choose an unnecessarily high level |
| Aerosolart | Defines a filtration and separation concept | Distinguish between oil, emulsion, and mixed contamination |
| Maintenance | Affects availability and performance | Plan for maintenance, filter access, and replacement intervals |
On smaller screens, the table can be scrolled horizontally.
Recirculation of separated liquid
Depending on the system design, separated liquid can be collected or recirculated. It is important to ensure a clear drain and piping that prevents backflow. Clogging or blocked drains can impair the separator’s function.
Adjusting Machine Exhaust Systems Correctly
An excessively high flow rate is not automatically better. In enclosed machines, excessive negative pressure can cause unwanted air currents or unnecessarily remove cooling lubricant from the process chamber. The goal is a stable, demand-based air exchange rate.
Common Mistakes
✔ Select an extraction unit based solely on the connection diameter
✔ Do not take the type of coolant into account
✔ Neglect liquid drainage and maintenance access
✔ Setting the flow rate unnecessarily high
✔ Do not consider mixed exposure to aerosols, smoke, and dust
Maintenance
Regular inspection of filter stages, liquid drainage, seals, and air pathways is crucial for consistently stable performance. Maintenance intervals should be based on the process, operating hours, and actual aerosol exposure.
FAQ
What is the difference between oil mist and dust?
Oil mist consists primarily of liquid aerosol droplets. This requires different separation methods than those used for dry industrial dusts.
Can an oil mist separator be mounted directly on the machine?
Depending on the design, direct installation or installation near the machine is possible. Load capacity, connection routing, and maintenance access must be taken into account.
How much flow rate is required?
This depends on the machine room, openings, process, and aerosol volume. A blanket selection based solely on connection diameter is not advisable.
Do filters need to be replaced regularly?
Yes, depending on the separation principle and filter stage. Pre-filters and fine filters may have different maintenance intervals.
Can the separated liquid be recirculated?
Depending on the system and process design, this may be possible. The suitability of the liquid and the design of the process must be verified.
What should be considered when dealing with mixed loads?
If smoke or dust is generated in addition to oil mist, the filter combination should be tailored to all relevant components.
Consulting on Oil Mist Separators
The selection depends on the machine, process, cooling lubricant, aerosol volume, desired flow rate, and installation situation. This information allows for a significantly more reliable design than a selection based solely on connection sizes.
